Ballast tanks are among the most demanding spaces in a ship: permanent seawater immersion alternating with void conditions, no natural light, poor ventilation, and limited access for repair once the vessel is in service. IMO's Performance Standard for Protective Coatings sets out what a compliant system looks like, and it is as much about preparation and inspection as about the paint itself.
Home/Application scenarios/Ship ballast water tanks
Ship ballast water tanks
Epoxy systems for ballast tanks under IMO PSPC, including surface preparation, stripe coating and inspection requirements.
Ship ballast water tanks — Epoxy systems for ballast tanks under IMO PSPC, including surface preparation, stripe coating and inspection requirements. Service environment: Immersion, seawater, C5-M internally; typical design life: 15 years (PSPC target). The table below lists the recommended coating build-up and links to the matching product categories and selectable products.
CorrosivityImmersion, seawater, C5-M internally
Typical service life15 years (PSPC target)
Recommended coating system
| Layer | Type & DFT | Product examples |
|---|---|---|
| Primer / build | Pure or high-solids epoxy, light colour, 2 coats | Pure epoxy tank coating |
| Total DFT | 320 µm nominal (PSPC minimum) | According to IMO PSPC |
| Stripe coat | Applied by brush before full coats on edges and welds | Same product as the main coat |
| Secondary surfaces | May use different product; same protection level | As per coated area |
Application critical points
- Surface preparation grade and salt contamination limits are specified explicitly under PSPC — visual cleanliness alone is not accepted evidence.
- Light-coloured coatings are normally required so that defects and corrosion are visible during inspection.
- Ambient conditions — steel temperature above dew point, relative humidity, ventilation — must be recorded continuously during application and curing.
- Repair after delivery follows the same standard as the original application; a coil or a small touch-up patch is judged against the same criteria.
Related product categories
Related products from the brands used in this scenario
Related brands & products
Frequently asked questions
Which coating system is recommended for Ship ballast water tanks?
The recommended build-up is: Primer / build; Total DFT; Stripe coat; Secondary surfaces.
What is the service environment for Ship ballast water tanks?
Service environment: Immersion, seawater, C5-M internally; typical design life: 15 years (PSPC target).
Which brands are covered by this scenario?
Brands covered by this scenario: HEMPEL, JOTUN, AkzoNobel International, NIPPON.
Articles are compiled by RichTech from publicly available manufacturer materials and field practice, for selection reference only; the latest official technical data sheets (TDS) prevail.
Not sure which product fits? Tell us the substrate and service conditions
Share your substrate, corrosivity category and target service life — we will come back with a coating system and quantity estimate.